GITHUB_SHA.h

@@ -1 +1 @@
-#define GITHUB_SHA "devel-202306261801Z"
+#define GITHUB_SHA "devel-202306231154Z"

MotorDriver.cpp

@@ -135,11 +135,7 @@ MotorDriver::MotorDriver(int16_t power_pin, byte signal_pin, byte signal_pin2, i
   // float calculations or libraray code. 
   senseFactorInternal=sense_factor * senseScale; 
   tripMilliamps=trip_milliamps;
-#ifdef MAX_CURRENT
+  rawCurrentTripValue=mA2raw(trip_milliamps);
-  if (MAX_CURRENT > 0 && MAX_CURRENT < tripMilliamps)
-    tripMilliamps = MAX_CURRENT;
-#endif
-  rawCurrentTripValue=mA2raw(tripMilliamps);
 
   if (rawCurrentTripValue + senseOffset > ADCee::ADCmax()) {
     // This would mean that the values obtained from the ADC never

config.example.h

@@ -57,21 +57,6 @@ The configuration file for DCC-EX Command Station
 //   +-----------------------v
 //
 #define MOTOR_SHIELD_TYPE STANDARD_MOTOR_SHIELD
-//
-/////////////////////////////////////////////////////////////////////////////////////
-//
-// If you want to restrict the maximum current LOWER than what your
-// motor shield can provide, you can do that here. For example if you
-// have a motor shield that can provide 5A and your power supply can
-// only provide 2.5A then you should restict the maximum current to
-// 2.25A (90% of 2.5A) so that DCC-EX does shut off the track before
-// your PS does shut DCC-EX. MAX_CURRENT is in mA so for this example
-// it would be 2250, adjust the number according to your PS. If your
-// PS has a higher rating than your motor shield you do not need this.
-// You can use this as well if you are cautious and your trains do not
-// need full current.
-// #define MAX_CURRENT 2250
-//
 /////////////////////////////////////////////////////////////////////////////////////
 //
 // The IP port to talk to a WIFI or Ethernet shield.

version.h

@@ -4,8 +4,7 @@
 #include "StringFormatter.h"
 
 
-#define VERSION "4.2.61"
+#define VERSION "4.2.60"
-// 4.2.61 - MAX_CURRENT restriction (caps motor shield value)
 // 4.2.60 - Add mDNS capability to ESP32 for autodiscovery
 // 4.2.59 - Fix: AP SSID was DCC_ instead of DCCEX_
 // 4.2.58 - Start motordriver as soon as possible but without waveform