#ifndef Config_h
#define Config_h
const int  WIFI_PORT =0xDCC;                         // (0xDCC is 3532 decimal) OR set to zero for no wifi 
const char WIFI_SSID[] PROGMEM = "BTHub5-M6PT";            // your network SSID (name)
const char WIFI_PASS[] PROGMEM = "49de8d4862";            // your network password
const long WIFI_BAUD_RATE=115200;

const long SERIAL_BAUD_RATE=115200;

// This hardware configuration would normally be setup using a bunch of #ifdefs.

const byte MAIN_POWER_PIN = 3;
const byte MAIN_SIGNAL_PIN = 12;
const byte MAIN_SIGNAL_PIN_ALT = 0;  // for hardware that flipflops signal pins 
const byte MAIN_SENSE_PIN = A0;   
const byte MAIN_SENSE_FACTOR=1; //  analgRead(MAIN_SENSE_PIN) * MAIN_SENSE_FACTOR = milliamps 
const byte MAIN_BRAKE_PIN = 9;

const byte PROG_POWER_PIN = 11;
const byte PROG_SIGNAL_PIN = 13;
const byte PROG_SIGNAL_PIN_ALT = 0;  // for hardware that flipflops signal pins 
const byte PROG_SENSE_PIN = A1;
const byte PROG_BRAKE_PIN = 10;

const float PROG_SENSE_FACTOR=1; //  analgRead(PROG_SENSE_PIN) * PROG_SENSE_FACTOR = milliamps 

// Allocations with memory implications..!
// Base system takes approx 700 bytes + 8 per loco. Turnouts, Sensors etc are dynamically created
const byte MAX_LOCOS=50;             

#endif