CommandStation-EX/Config.h

#ifndef Config_h
#define Config_h

// This hardware configuration would normally be setup using a bunch of #ifdefs.

const byte UNUSED_PIN = 255;

const byte MAIN_POWER_PIN = 4;
const byte MAIN_SIGNAL_PIN = 7;
const byte MAIN_SIGNAL_PIN_ALT = UNUSED_PIN;  // for hardware that flipflops signal pins 
const byte MAIN_SENSE_PIN = A0;   
const byte MAIN_BRAKE_PIN = 9;
const byte MAIN_FAULT_PIN = 12;

const int   MAIN_MAX_MILLIAMPS=2000;
const float MAIN_SENSE_FACTOR=18; //  analgRead(MAIN_SENSE_PIN) * MAIN_SENSE_FACTOR = milliamps 

const byte PROG_POWER_PIN = 2;
const byte PROG_SIGNAL_PIN = 8;
const byte PROG_SIGNAL_PIN_ALT = UNUSED_PIN;  // for hardware that flipflops signal pins 
const byte PROG_SENSE_PIN = A1;
const byte PROG_BRAKE_PIN = 10;
const byte PROG_FAULT_PIN = UNUSED_PIN;

const int   PROG_MAX_MILLIAMPS=250;
const float PROG_SENSE_FACTOR=18; //  analgRead(PROG_SENSE_PIN) * PROG_SENSE_FACTOR = milliamps 

// Allocations with memory implications..!
// Base system takes approx 900 bytes + 8 per loco. Turnouts, Sensors etc are dynamically created
const byte MAX_LOCOS=50;             

#endif