mirror of
https://github.com/DCC-EX/CommandStation-EX.git
synced 2024-11-23 08:06:13 +01:00
32 lines
1.2 KiB
C
32 lines
1.2 KiB
C
#ifndef Config_h
|
|
#define Config_h
|
|
|
|
// *** PLEASE NOTE *** THIS FILE IS **NOT** INTENDED TO BE EDITED WHEN CONFIGURING A SYSTEM.
|
|
// It will be overwritten if the library is updated.
|
|
|
|
// This file contains configurations for known/supported motor shields.
|
|
// A configuration defined by macro here can be used in your sketch.
|
|
// A custom hardware setup will require your sketch to create MotorDriver instances
|
|
// similar to those defined here, WITHOUT editing this file.
|
|
|
|
// Define these if you have a WiFi board on Serial1
|
|
#define WIFI
|
|
#define WIFI_CONNECT_TO_SSID "RPi-JMRI"
|
|
#define WIFI_CONNECT_PASSWORD "rpI-jmri"
|
|
|
|
const byte UNUSED_PIN = 255;
|
|
|
|
// MotorDriver(byte power_pin, byte signal_pin, byte signal_pin2, byte brake_pin, byte current_pin, float senseFactor, unsigned int tripMilliamps, byte faultPin);
|
|
|
|
// Arduino standard Motor Shield
|
|
#define STANDARD_MOTOR_SHIELD \
|
|
new MotorDriver(3 , 12, UNUSED_PIN, 9, A0, 2.99, 2000, UNUSED_PIN), \
|
|
new MotorDriver(11, 13, UNUSED_PIN, 8, A1, 2.99, 250 , UNUSED_PIN)
|
|
|
|
|
|
// Allocations with memory implications..!
|
|
// Base system takes approx 900 bytes + 8 per loco. Turnouts, Sensors etc are dynamically created
|
|
const byte MAX_LOCOS=50;
|
|
|
|
#endif
|