CommandStation-EX/Release_Notes/duinoNodes.md

Using Lew's Duino Gear boards:

1. DNIN8 Input This is a shift-register implementation of a digital input collector. Multiple DNIN8 may be connected in sequence but it is IMPORTANT that the software configuratuion correctly represents the number of boards connected otherwise the results will be meaningless.

   Use in myAnimation.h

   HAL(IO_DNIN8, firstVpin, numPins, clockPin, latchPin, dataPin) e.g. HAL(IO_DNIN8, 400, 16, 40, 42, 44)

   OR Use in myHal.cpp IO_DNIN8::create( firstVpin, numPins, clockPin, latchPin, dataPin)

   This will create virtaul pins 400-415 using two DNIN8 boards connected in sequence. Vpins 400-407 will be on the first board (closest to the CS) and 408-415 on the second.

   Note: 16 pins uses two boards. You may specify a non-multiple-of-8 pins but this will be rounded up to a multiple of 8 and you must connect ONLY the number of boards that this takes.

   This example uses Arduino GPIO pins 40,42,44 as these are conveniently side-by-side on a Mega which is easier when you are using a 3 strand cable.

The DNIN8K module works the same but you must use DNIN8K in the HAL setup instead of DNIN8. NO you cant mix 8 and 8k versions in the same string of boards but you can create another string of boards.

DNOU8 works the same way, Use in myAnimation.h

HAL(IO_DNOU8, firstVpin, numPins, clockPin, latchPin, dataPin) e.g. HAL(IO_DNIN8, 450, 16, 45, 47, 49)

OR Use in myHal.cpp IO_DNIN8::create( firstVpin, numPins, clockPin, latchPin, dataPin)

This creates a string of input pins 450-465. Note the clock/latch/data pins must be different to any DNIN8/k pins.